Msd 8998 Single Channel Digital Ignition Tester Instal Manual de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 8
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
INSTALLATION INSTRUCTIONS 7
M S D W W W . M S D P E R F O R M A N C E . C O M ( 9 1 5 ) 8 5 7 - 5 2 0 0 F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
TIPS & TROUBLESHOOTING:
No spark after Tester is connected:
• Inspect the wiring of the tester. Make sure you have a good ground and 12 volt source.
• Check to make sure you have the correct testing program for your application.
• Swap another coil in and repeat the test. If spark occurs, the coil is at fault.
Figure 11 Testing a Dual Coil MSD 10 Ignition.
NOTE: THE DUAL COIL MSD 10 HAS BEEN REPLACED
BY THE MSD 10-PLUS IGNITION.
Vista de pagina 6
1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios